Technical Presentations

Wide-area EMT simulation of Colombian Power system with high inverter-based-resources penetration and weak SCR network900

Abstract
This presentation will focus on a specific issue of bipolar HVDC lines with a dedicated metallic return (DMR). DMR is insulated to a lower level than the pole and its insulators are shorter. One event... see more, for example, pole-to-ground-fault will cause a fault on both the pole insulation and the DMR insulation simultaneously because the DMR insulation fault will be supported by the DC current and will turn into a DC arc. To ensure independent pole operation, these types of events should be avoided or, if the DMR does flashover, to extinguish the fault as soon as possible. This is phenomena are presented and how different solutions are tested with EMTP software to protect the DMR.

Tag(s): Colombian Power System, EMT Model, Solar Power, Wind Power

Reactive Power Energy Management, Analysis of Reactive Power Consumption in Solar Power Plant847

Abstract
For any Power Plant, it is aimed to have maximum Energy Generation and yielding for the Power Output. Solar power plant comprises PV cells, framing array by connecting with each solar panel and then c... see moreonnected with step-up transformer (Inductive element) by cable network (capacitance formed). The energy generated by PV cells are being converted by Solar inverters (Power electronics) and operated at almost Unity Power Factor.
It has been observed that with export of Active energy and increasing output, there is also import of Reactive energy varying with solar generation. The Tariff charges are involved and applicable for Reactive Power Consumption in said solar power plant. Active energy also imported during evening and night hours in absence of solar generation to run critical equipments and trend between active and reactive energy has been observed vice versa.
As per the State Tariff regulations, beneficiary must pay/gets paid for reactive power drawl/supply which is decided and bounded by the system voltage limit (e.g. 97% to 103% of Rated system voltage).

Considering varying MVAR absorption phenomena associated with active power generation and effect of supply voltage, it has been decided to study and model solar generation in EMTP. Different cases have been simulated in EMTP software. Major sources consume Reactive Power identified from modelling and matched observation with actual recorded data. Mitigation technique for reactive power compensation has been studied and modelled. Rating for reactive power compensation source has been validated. Switching phenomena associated with reactive power compensation technique along with voltage profile at different points has also been studied and appropriate rating for switching devices/switchgear has been suggested.
Detail study and simulation results will be shared during presentation.

Tag(s): reactive power, compensation, pv park, inverter

Dynamic Overvoltage Conditions Experienced at a PV Solar Power Plant838

Abstract
We present the results from an investigation of the cause of dynamic overvoltage conditions experienced at a solar power plant, that resulted from energizing the PV solar plant 34.5 kV collection syst... see moreem feeders using a back-up diesel generator. The diesel generator unit was installed at the solar plant for emergency back-up power to the project, in case of power outage from the connecting transmission utility system.
The back-up power source was provided to allow the operation of the solar power tracking system during emergency conditions. A subsequent study was performed using EMTP software program, to investigate the cause of these dynamic overvoltage conditions at the solar power plant. A detailed transient model of the solar plant and the diesel generator were developed using EMTP.


The EMTP simulations were useful in replicating the overvoltage event measurement recordings from the site, and the simulation results from the study, concluded that the diesel generator did not have sufficient capability to pick up capacitive loads and therefore, the unit was unable to control the overvoltage conditions which led to the overvoltage event that caused equipment damage to the PV inverters and their auxiliary systems. The study evaluated various solution alternatives and mitigation strategies to reduce these dynamic overvoltages to acceptable conditions.

Tag(s): pv park, tov, diesel generator, temporary overvoltage

Modeling of energy systems with renewable energy sources779

Abstract
The webinar presents a module for modeling renewable energy sources (Renewable Energy Systems) The module contains detailed models of wind and solar power plants and is successfully used to analyze va... see morerious types of steady state and transient processes: flux distribution, under- and over-voltage operation, switching overvoltages, subsynchronous oscillations, etc