Technical Presentations

FFOV Analysis for 500 kV Substation901

Abstract
This is a presentation on lightning overvoltage analyses for a 500/220 kV substation. Highlights: An interesting application case where the electrical distance between the surge arrester and transform... see moreer was quite long, requiring us to check the adequacy of the surge arrester. Proper selection of lightning parameters in line with CIGRE TB063 (updated in 2021). We can provide some easy-to-use recommendations for lightning waveform modeling. Modeling of substation apparatus, including some brief guidelines and critical points not to miss.

Tag(s): Lightning Overvoltage Analysis, Surge Arrester

Insulation coordination study of 220 kV transmission line for reliability improvement against lightning-induced overvoltages877

Abstract
This presentation shows a detailed insulation coordination verification using EMTP. It includes an accurate representation of transmission line components considering actual site data such as conducto... see morer arrangement, line length, line parameters, insulator details, tower structure and location, tower grounding resistance, and lightning data.

Tag(s): Insulation Coordination, Lightning Strike, LIOV, Line Surge Arresters, Back-Flashover

Response of Overhead Lines to Direct Lightning Strikes: Assessment of the LEMP Effects852

Abstract
In the usual practice, the evaluation of the overvoltages due to direct lightning strikes to overhead power line conductors is focused on the representation of the effects of the lightning current inj... see moreection, whilst the effects of the coupling between the conductors and the lightning electromagnetic pulse (LEMP) is disregarded. Motivated by recent results obtained for the case of a medium voltage line configuration with a shield wire, this extends the analysis to assess the contribution of the LEMP on the lightning performance of an overhead distribution with and without periodically grounded wires and surge arresters. Moreover, the presentation deals with the LEMP effect on the occurrence probability of flashovers on different phases, which is an important information on the service continuity of networks with isolated or compensated neutral earthing. A validation of the results is obtained by comparing the overvoltages calculated by using EMTP, together with the LIOV library for the LEMP calculation, and those obtained by a three-dimensional finite difference time-domain approach.

Tag(s): lightning, pulse, LIOV, surge, arrester

Insulation Coordination Study of 765kV GIS SUBSTATION788

Abstract
Gas Insulated Substations provide cost effective solution due to reduced land requirements particularly in metropolitan area where power demand is registering steep growth. With the use of GIS technol... see moreogy, it is required to assess the risk of failure due to overvoltage. The Insulation Coordination study forms a very important aspect in design stage. This presentation deals with the IC study carried out for a large – 765/400/220kV GIS substation in a SUPER THERMAL POWER STATION in UTTAR PRADESH.


Due to the decreasing ratio of lightning impulse withstand voltage to the system voltage, the difference between LIOV and VFTO decreases and this factor calls for VFTO performance analysis for 765kV GIS as well.
The discussion includes modeling of Extra High Voltage GIS, Temporary Overvoltage (TOV), Lightning Impulse Overvoltage (LIOV), Switching Overvoltage (SOV) and Very fast transient Overvoltage (VFTO) performance analysis on 765kV GIS substation.
TOV typically caused by fault to ground, load rejections and energization of long lines are analyzed to decide the rating of the surge arrester.
LIOV simulation studies are carried out for possible onerous paths including longer and short paths to decide the location of the arrester. SOV analysis deals with the overvoltage due to switching operations during line energization, re-energization and fault occurrence and clearance.


The LIOV and SOV results have been validated with reference to protective levels prescribed. The VFTO analysis is performed with various GIS disconnector operations in accordance with the methodology and guidelines as per CIGRE WG D1.03-TB 519 and the results are validated with the limits specified.
Keywords: Insulation Coordination, VFTO, EHV, GIS, 765kV, Protective ratio.

TOV for renewable, evaluating three different grounding technologies783

Abstract
Temporary overvoltages (TOV) are oscillatory overvoltages mainly caused by switching or faults, which are of relatively long duration and undamped or slightly damped. Maximum overvoltages under faulte... see mored conditions can require considerable energy magnitudes absorbed by surge arresters.
These energies may overpass maximum limits and lead to equipment damage.

This project presented a study to identify the maximum TOV at the MV equipment of a PV power plant during fault-clearing events. Two methods of TOV suppression are evaluated, including grounding transformers and fast grounding switches under two different configuraions. An electrical model was elaborated in EMTP to perform the simulation of the transient overvoltage due to the un-balanced fault clearance, considering each inverter of the PV plant. The results show that considering no grounding technologies at the feeders, the energy absorption limit is overpassed in the islanded system.

Therefore, a fast grounding switch or a system with grounding technology at each feeder is needed in order to protect the substation equipment.